Muse ML-60 IP User Manual download pdf (Page 2)

GB - 12

GB - 10

GB - 8

GB - 9 GB - 11

Made for iPod and iPhone

"Made for iPod," "Made for iPhone," and "Made for iPad" mean that an

electronic accessory has been designed to connect specifically to iPod,

iPhone, or iPad, respectively, and has been certied by the developer to meet

Apple performance standards. Apple is not responsible for the operation of

this device or its compliance with safety and regulatory standards. Please

note that the use of this accessory with iPod, iPhone or iPad may affect

wireless performance.

LISTEN TO YOUR iPhone/iPod

iPhone call pick up

1. When phone call coming in, the music from the docking iPhone will pause

automatically.

2. Incoming call ring comes out from the unit speaker.

3. You can take iPhone from the unit and pick up phone call.

4. After nish your call, connect back the iPhone to the socket, it will resume

the playback of iPhone.

Charge your iPhone/iPod

While your iPhone/iPod is docked on the system, its battery recharges

automatically until fully charged.

Clock Time Synchronization

The rst time when your unit connected with iPhone, the clock time of your

unit will be synchronous with the iPhone.

After the rst time, you are required to press and hold M/SET button for 5

seconds to set your unit synchronous with iPhone.

iPhone/iPod interchangeable adapter

This system includes 5 different adapters designed to allow you to securely

connect any “dockable” iPhone/iPod model to the docking station. Refer to

the chart below to select the proper adapter for your particular iPhone/iPod

model and insert that adapter into the docking station before connecting your

iPhone/iPod.

IMPORTANT

The docking station in this system follows the Apple “Universal Dock” design.

This system can be tted to different iPhone or iPod model.

Play your iPhone/iPod on the main unit

1. Connect your iPhone/iPod to the socket of the unit.

2. Press the ON/OFF button to turn on the unit.

3. Press to select iPhone/iPod mode. The display indicates “ ”.

4. Press button to play or pause. Press and hold this button for 5

seconds to enter the iPod/iPhone sleep mode.

5. Select the previous or next track by pressing / button, press and

hold / on the unit to play review or fast forward.

6. Press VOL + / - buttons to adjust sound level.

Other iPhone/iPod functions MENU, OK (Select), ▲ (UP) and ▼ (DOWN)

are performed by the remote control.

MENU button: Press to return to previous page of menu.

▲or ▼ button: press to select a menu item.

OK button: press to confirm a selection (open a folder or start playing a

selected track).

AUXILIARY

This unit includes the AUX IN jack to allow you to connect external devices,

such as MP3 player, and listen to the music of your external device through

the speakers of this unit.

1. Connect the external device to the AUX IN jack at the back of the unit.

2. Press ON/OFF button, AUX icon shows on the display, and function mode

switch to AUXILIARY.

3. Start to play your auxiliary source.

4. Adjust the volume to desired level.

5. To stop playback, press ON/OFF button, or disconnect your external

device from the AUX IN jack.

SPECIFICATIONS

GENERAL

Power source AC 100-240V ~ 50/60Hz

DC 3V, 2x1.5V “AAA/R03/UM4” size batteries (not included) or

equivalent for memory backup

Dimension 120 W * 312 H * 178 L mm

TUNER

Frequency range: FM: 87.5 - 108 MHz

AUDIO SECTION

Power Consumption 15W

Speaker Impedance 8 ohm

MORE INFORMATION

ATTENTION : To reduce the risk of electric shock, do not

remove the cover. There are no user serviceable parts

inside the unit. Refer all servicing to qualied personnel.

The exclamation point within the triangle is a warning sign alerting

the user of important instructions accompanying the product.

The lightening ash with arrowhead symbol within the triangle is a

warning sign alerting the user of “dangerous voltage” inside the unit.

IMPORTANT

If at any time in the future you should need to dispose of this

product please note that Waste electrical products should not be

disposed of with household waste. Please recycle where facili-

ties exist. Check with your Local Authority or retailer for recycling

advice.(Waste Electrical and Electronic Equipment Directive)

WARNING - To reduce the risk of re or electric shock, do not expose this

appliance to rain or moisture.

For indoor use only

Class 1 LED product.

Do not throw batteries in re!

Do not place the product in closed bookcases or racks without proper

ventilation.

If the external exible cable or cord of this luminaire is damaged, it shall be

exclusively replaced by the manufacturer or his service agent or a similar

qualied person in order to avoid a hazard.

Attention should be drawn to the environmental aspects of battery disposal.

The marking information is located at the bottom of apparatus.

Ensure a minimum distance of 5cm around the apparatus for sufficient

ventilation.

Ensure that the ventilation is not impeded by covering the ventilation

openings with items, such as newspapers, table-clothes, curtains, etc.

Do not place naked flame sources, such as lighted candles on the

apparatus.

Use the apparatus only in moderate climates.

Do not be exposed to dripping or splashing. And that no object lled with

liquids, such as vases, shall be placed on the apparatus.

Do not use your set immediately after transport from a cold place to a warm

place, there may be condensation problems.

Make sure that you keep your set away from water and high temperatures.

Clean the player with a soft cloth, or damp chamois leather. Never use

solvent.

To be completely disconnected the power input, the mains plug of the

apparatus shall be disconnected from the mains completely.

The mains plug should not be obstructed or should be easily accessed

during intended use.

Where the mains plug is used as the disconnect device, the disconnect

device shall remain readily operable.

Under the influence of electrical fast transient or/and electrostatic

phenomenon, the product may malfunction and require user to power reset.

GB - 13

2. To stop the alarm for 24 hours, press ON/OFF button, alarm source indica

tors remain displayed. The alarm will trigger at the preset time one day

later.

3. To turn off the alarm permanently, press ALM 1 or 2 button in standby

mode until alarm source indicators disappears.

NOTE:

- You can adjust the wake up sound level by VOL+/- button in wake up by

iPhone/iPod or radio modes.

- But since this is a progressive alarm, the sound will be louder and louder.

You could decrease the volume after the alarm reaches to its max volume

level.

LIGHTING

1. Press button once to turn on the main light. The current level of

brightness will show on display for 5 seconds.

2. Press button repeatedly to adjust the level of brightness (from 01 to

20).

Color light

1. Press button twice to turn on the color light, then it will start to cycle in

different colors.

2. Press button to stop at current color, press this button again to

resume the cycle.

3. Press button again to turn off the light.

NATURAL SOUNDS

1. In standby mode, press button to trigger natural sound function.

“ 01” will show on display.

2. Press button repeatedly to select a kind of natural sound among six.

3. Press VOLUME +/- to adjust the volume level.

NAT

LISTENING TO THE RADIO

Manual operation

1. Press ON/OFF button to turn on the unit.

2. Press FM button to select RADIO mode, “ ” shows on display.

3. Press / to tune to a desired station step by step.

Note: Press FM button directly in standby mode also can enter RADIO mode.

Automatic search operation

The automatic searching operation locates strong stations. Press and hold

/ button to start automatic searching in the chosen direction. Press

again to stop

searching. A station with a weak signal can be tuned manually.

NOTE: During the search operation the sound level will be muted

automatically.

Program preset stations

This unit is able to store 20 FM radio stations in memory.

1. Select a radio station either by manual or automatic search.

2. Press M/SET button once, “M” and preset number will ash on display.

3. Press ALM. 1 or ALM. 2 button to change preset number.

4. Press M/SET button again to save the radio station in the selected preset

channel.

5. Repeat steps 1-4 to store more stations.

When you memorize a station on a preset, the previous station is erased and

replaced by the new one.

Listening to the preset stations

Press ALM.1 or ALM.2 button directly to select a preset station.

NOTE: For a better reception in FM, extend the antenna. If a stereo

broadcast is received, “FM(ST)” is displayed.

Your clock radio is equipped with a saving energy LED main light and

multicolor ambience light.

Main light

GB - 8

GB - 14 GB - 15

NOTE: No adapter is provided for the 3G (third generation) iPod.

Please use the adapters which were included with your iPod at the time of

purchase. They will t properly into the docking station of this system.

LA-2883 IB MUSE 001 REV0 -GB.ind2 2 2011-3-10 16:33:34

1 2

User Manual 1
Class 1 LED product 2

Comments to this Manuals

No comments

Muse ML-60 IP User Manual Page 2

Comments to this Manuals